Rear Fender

Even after running out of oxygen for the torch and blowing the motor up on the compressor, I managed to get a lot done.

I spend most of Saturday working on a few little things (tacked in motor mounts) and then filling in a patch for the rear oem fender where the old tail light was.

Old stock hole for the tail light.

Old stock hole for the tail light.

Old Taillight Hole Closeup

Old Taillight Hole Closeup

Paper template for the piece needed

Paper template for the piece needed

Template Traced

Template Traced

Template Cutout.  Cut close to size and then finished afterwards on the grinder.

Template Cutout. Cut close to size and then finished afterwards on the grinder.

Test Fitting

Test Fitting

Welded into place - ready for blending

Welded into place - ready for blending